Redmax HEZ2500F Manual do Utilizador

OWNER/OPERATOR MANUALSTICK EDGERS848-A41-93A1 (501)HE225FHEZ2500FThe engine exhaust from this productcontains chemicals known to the Stateof Californi

 10 the throttle is moved fully back to its originalposition. If it continues to rotate even after thethrottle has been moved fully back, turn off t

MAINTENANCE1. In order to maintain your product in properworking order, perform the maintenance andchecking operations described in the manual atreg

 12 5. For safe operation HANDLING FUEL1. The engine of the RedMax product is designedto run on a mixed fuel which contains highlyflammable gasolin

SE4 MOUNTING ENGINE (SE1)1. Push the driveshaft housing toward the clutchhousing and rotate it by hand to check that thedriveshaft is engaged with th

 14 7. Fuel RECOMMENDED MIXING RATIOGASOLINE 50:OIL 1• Exhaust emission are controlled by thefundamental engine parameters andcomponents(eq., carbu

7. Fuel 15 again for at least one minute. As someoils may be difficult to agitate dependingon oil ingredients, sufficient agitation isnecessary for

 16 8. OperationOP2(1)(2)(3)OP1(1)(2)(3)OP3(4)(7)(5)(6)OP4The RedMax stick edgers are designed for edginglawn in gardens, parks, roadsides and so on

8. Operation 17 • Avoid pulling the rope to its end or returning it byreleasing the knob. Such actions can causestarter failures.6. Move the choke l

 18 8. Operation HOW TO USE1 Always wear eye protection such as safetygoggles. Never lean over the rotating cuttinghead. Rocks or other debris coul

•Always be sure to stop the engine before inspecting the stick edger for problems orperforming maintenance.• Never alter the stick edger or take the e

 20 •Make sure that the engine has stopped and iscool before performing any service to themachine. Contact with moving cutting heador hot muffler ma

MUFFLER• Inspect periodically, the muffler for loosefasteners, any damage or corrosion. If any signof exhaust leakage is found, stop using themachin

 22 9. Maintenance BLADE (MA7)• Place the blade between holders (A) and (B)while locking the gear shaft by putting the bar,through the key holes on

10. Storage• Aged fuel is one of major causes of enginestarting failure. Before storing the unit, empty thefuel tank and run the engine until it uses

 24 11. Troubleshooting guideCase 1. Starting failure CHECK PROBABLE CAUSES ACTIONfuel tank ➞ incorrect fuel ➞ drain it and with correct fuelfuel fi

12. Parts list NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/orreplacement. 2. KOMATSU ZENOAH does not warr

12. Parts list  26 Fig.1 DRIVE UNIT (S/N 200001 and up)

Fig.1 DRIVE UNIT (S/N 200001 and up)Key# Description Part Number Q'ty1PIPE COMP. T3207-12100 12 SHAFT COMP. T3207-12200 13 GEARCASE ASSY T3207-13

12. Parts list  28 Fig.2 ENGINE UNIT HE225F (S/N 50100000 and up)

Fig.2 ENGINE UNIT HE225F (S/N 50100000 and up)Key# Description Part Number Q'ty1 CYLINDER 5580-12110 12 GASKET, base 5500-12213 13 BOLT 1850-121

SAFETY FIRSTInstructions contained in warnings within thismanual marked with a symbol concerncritical points which must be taken intoconsideration to

Fig.3 ENGINE UNIT HEZ2500F (S/N 50100000 and up) 30 12. Parts list

Fig.3 ENGINE UNIT HEZ2500F (S/N 50100000 and up) 31 Key# Description Part Number Q'ty1 CYLINDER 848-F30-12A2 12 GASKET, base 4810-12210 13 BOL

EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY OF THE UNIT, KOMATSU ZENOAH AMERICA INC. (THE COMPANY), THROUGH ANY RedMa

Pièces en rapport avec les émissions de gaz d'échappement : KOMATSU ZENOAH AMERICA INC., parl'intermédiaire de n'importe quel revendeur

KOMATSU ZENOAH AMERICA INC.4344 Shackleford Road Suite 500Norcross, Georgia 30093©Printed in Japan

2. Specifications HE225F/HEZ2500FOverall size(LxWxH) ································ 68.1(1730)x12.3(313)x12.3(312) / 69.8(1773)x12.6(320)x12.3(312)

 5 3. Warning labels on the machine(1) Read owner's manual before operating this machine.(2) Wear head, eye and ear protection.(3) Warning/Atte

 6 For safe operation and maintenance, symbols arecarved in relief on the machine. According to theseindications, please be careful not to take a mi

5. For safe operation1. Read this manual carefully until youcompletely understand and follow all safetyand operating instructions. 2. Keep this manual

 8 b. At night, at times of heavy fog, or at any othertimes when your field of vision might belimited and it would be difficult to gain a clearview

BEFORE STARTING THE ENGINE1. The area within a perimeter of 50 feet (15m) ofthe person using the product should beconsidered a hazardous area into w